Curriculum
Details
Sample
Activities
SIP401 Electronics for Automated Controls
An Introductory Course covering solid-state devices which are often used in motor controls. Two prewired panels contain the various circuits. Analog and digital devices, as well as start-stop relay control circuits, are included in this study. Some basic semiconductor devices, such as diodes, amplifiers, and integrated circuits, are also included. The course provides for approximately 75-90 hours of instruction.
EQUIPMENT SPECIFICATIONS
PANEL SIP401-1P: SOLID-STATE DEVICES
 | Start-stop basic control circuitry demonstrates basic control of a motor |
|
Rectifiers are connected in full-wave with a filter and regulator, plus a bridge rectifier with a three-terminal regulator |
|
Transistor Inverter Amplifier Circuit |
|
JFET Amplifier Circuit |
|
MOSFET Amplifier Circuit |
|
Noninverting and Inverting types of IC Circuits |
|
Adding and Summing Circuits |
|
Buffer or Follower Circuit |
|
DIP switches are provided to control the on/off operation of various circuits |
PANEL SIP401-2P: ELECTRONICS FOR AUTOMATED CONTROLS
| Contains Up/Down Counter Circuits |
REQUIRED EXTRA EQUIPMENT
Power
Supply Base (S300PSB)
or
Smart Builder (S400)
All equipment
operates on 120/240 VAC, 50/60 Hz.
LABORATORY MANUAL
The
following Table of Contents indicates the scope of the material and
experimentation provided by this course.
|
An Introduction to Automated Systems |
|
Solid-State Power: Diodes, Rectifiers, Regulators |
|
Transistors and Operational Amplifiers |
|
Basic Logic Concepts and Circuits |
|
Oscillators, Generators, and Filters |
|
Optoelectronic Devices: Light Emitters, Sensors, Couplers, and Fibers |
|
Thyristors: The SCR, Diac, and Triac |
|
Solid-State Mechanical Motion Sensors: Hall-Effect and Proximity |
|
Electromechanical Switching Devices |
ORDERING INFORMATION
For the
complete course, consisting of two panels and lab manual, order SIP401C.
For additional manuals, order SIP401CM.
TOTAL WEIGHT: 7
lbs (3.2 Kg)